Find great deals for JBL h 18″ w RMS Neo Woofer x 8 Ohm Low Frequency Transducer. Shop with confidence on eBay!. Find great deals for JBL h 18″ Speaker x 8 Ohm. Shop with confidence on eBay!. ok who have any info on jbl h. Will this LF driver be used in home stereo market besides pro. Will this LF driver replace the
|Published (Last):||8 August 2018|
|PDF File Size:||20.95 Mb|
|ePub File Size:||5.70 Mb|
|Price:||Free* [*Free Regsitration Required]|
JBL 2269H 18″ Low Frequency Transducer 354096-001X
Originally Posted by mobeer4don. Probably little to no difference for a low tuned build.
I guess my question really come down to finding the solution that is most tolerant of being driven stupid loud at 20Hz while yielding acceptable SQ. Let’s assume watts peak Crown XTi bridged mono Need a little help Originally Posted by LTD I don’t know much about them but Parts Express has an 18″ model.
I picked up a H to build a Sub18 clone go with my M2 clones or close enoughs. Keeping within the spirit of the SUB18, but going bigger cab, bigger ports, lower tuning Remove Advertisements Sponsored Links.
No doubt bigger is better but this is going in the living room so sticking closer to the original size is a good idea.
Come to think of it I could incorporate the slot port into a riser to get it up off the floor and eliminate the “problem” of the port consuming box volume assuming I give up on round ports. I’m not sure if a single p.
Wow Don-where were you able to find the ? Not much extra work to have the option of testing both configurations.
Haven’t done the math on slot ports because the first goal was to match the Sub18 look if you can bjl it that. What does that sound like? Unfortunately the port velocity is very high for the 4″ ports below 40Hz. Guessing from the photo ports are JBL H – ported or passive? Last edited by LTD02; at Anyone know where to find a 5″ diameter flared port? The Sub18 specs http: Next thought was to look at a passive 2269n.
JBL 2269h 18″ 2400w RMS Neo Woofer 354096-001x 8 Ohm Low Frequency Transducer
BB code is On. I also have some rosewood veneer I plan to use and need to verify the dimensions before I get too far into it. Originally Posted by Wrager. Any help or advice on optimization would be appreciated.
I used the 3″ Precision Ports on the M2 clone so I figured kbl pair of the 4″ or 6″ should do the trick. AVS Forum articles Contests.
ok who have any info on jbl h
For the best viewing experience please update your browser to Google Chrome. I’m not sure if the ports are straight ports or not.
My new CNC router is limited to about 31″ x 32″ Runs out of excursion between 20 and 30 Hz depending on added mass. You guys are a great resource. I suspect I won’t be running near peak power except to show off the system occasionally.