Notice: OMRON products are manufactured for use according to proper procedures .. You can install multiple 3G3JX inverters side by side in the control panel. Simple, Compact Inverters SYSDRIVE JX Series . Model name (3G3JX-) In no event shall the responsibility of OMRON for any act exceed the individual. Inverter 3G3JX . Use this terminal block to connect the inverter to the Sysmac® is a trademark or registered trademark of OMRON Corporation in Japan and.

Author: Mautaxe Kagaktilar
Country: Grenada
Language: English (Spanish)
Genre: Literature
Published (Last): 8 May 2004
Pages: 442
PDF File Size: 16.32 Mb
ePub File Size: 9.96 Mb
ISBN: 785-1-58573-275-3
Downloads: 31599
Price: Free* [*Free Regsitration Required]
Uploader: Nazuru

Enter key To change the set value, be sure to press the Enter key. S-shape curve Deceleration pattern Chapter 7 Specifications Standard Specification List Page 16 Contents Connection Example The monitor LED indicator “V” lights up.

Alarm output for momentary power interruption and undervoltage during stop Examples 3 and 4 Example 3 b Do not operate the Digital Operator or switches with wet hands. Specified data has omroh unacceptable format. Change the 1st digit of the function code. Trip after frequency matching deceleration stop Allowable b Output Current Monitor [d] Displays the output current value of the Inverter. Comments to this Manuals Your Name. By factory default, the input logic of the multi-function input terminal circuit is set to the sink logic.


Page Options If the offset C is changed, the point to reach 10 V changes accordingly because of par- allel movement. Wiring work must be carried out only by qualified 33jx.


C to C contact selection are excluded. Page Function Mode 2nd Control Function and Special 2nd Function This function is used to operate by switching two different types of motors.

A holding brake is not a stop motion device designed to ensure safety. The Inverter does not allow this function.

Page Function Mode a Edge operation A The code of the monitor mode is displayed as “d”. Below are the contact specifications of the relay output.

Not doing so may result in a serious injury due to an electric shock. The monitor LED indicator “Hz” lights up while inevrter is displayed. With this function, output voltage to the motor is based on that set in the AVR voltage selection. Factory Default Operation Procedure Example: A FI end ratio 0. Page 59 Page 60 – Operation Procedure Example: This manual should be delivered to the actual end user of the product.

This helps prevent data rewrite due to erroneous operation. Function name Data Knverter setting FA2 over set frequency arrival signal C output terminal P1 Data other than b and specified frequency parameters cannot be changed when the SFT terminal is ON.


Omron 3G3JX User Manual

Omrom not share the grounding electrode with other strong electrical devices. After completing the installation process, be sure to remove the covers from the Inverter before operation.

Stops with auto recovery contacts. You cannot set analog inputs FV and FI to both target and feedback values simultaneously.

Keys Keys Keys Name Description Switches between the command setting and the data setting, and between the extended function mode and the basic function mode. ON Multi-step speed setting binary 1 Binary operation 1: Page Special Display List Display on Digital Name Description Operator Shuts off the output if a ground fault between the Inverter output unit and the motor is detected when turning on the power.

Got it, continue to print. Page 94 Function Mode Parameter No. A general-purpose noise filter 3g3mx be less effective and may not reduce noise.