Comnav Pdf User Manuals. View online or download Comnav Installation And Operation Manual. ComNav Autopilot Manual. Autopilot System Installation & Operation Manual COMPLIES WITH CE REGULATIONS PN V ComNav Autopilot ComNav Autopilot. READ. Show more . Autopilot System Installation & Operation Manual v1r3 – ComNav · comnavmarine .

Author: Vumuro Motaur
Country: Qatar
Language: English (Spanish)
Genre: Life
Published (Last): 12 February 2017
Pages: 491
PDF File Size: 4.77 Mb
ePub File Size: 8.98 Mb
ISBN: 704-5-31971-571-5
Downloads: 85718
Price: Free* [*Free Regsitration Required]
Uploader: Mezinos

To steer a constant Heading, the Autopilot compares the compass information with the Heading Course that the operator has selected.

If you wish to follow the comnsv method and drain the system, use the following simple procedure. Then press the Red Key 9 times.

Two Line systems, and Three Line systems. Press the Speed Key The autopilot will comav begin to make a number of rudder movements. The stripped ends of wire must not be able to touch each other. If the pilot light goes off, followed by blinking port and starboard lights, you have reached the lowest level of the Slow Response Sensitivity.

Press the Pilot Key again, and your Autopilot will steer your boat along your new Course. Turn your vessel, or simply turn the compass, until the compass is pointing due North. The arrow must point in the same direction as the bow of your boat.


This part includes 25 feet 7.

comnav 1460

Do not cut or crimp any wires while tightening the screws. It was tested according to the applicable sections contained in: If you must use a tool, 160 very careful. Enter a Waypoint into the navigation device. Bleed your manual steering system according to the manufacturer’s instructions. Each Rudder Response setting controls the steering in a very different way. The Clip is mounted using four 10 5 mm fasteners supplied by you: Wait a few minutes, and see if the boat settles on a steady Course.

You must always be in a position to monitor the course, supervise the autopilot, and resume manual control if the need to do so arises. We suggest that you do it first! Use the Control Head to extend the rod fully in one direction and then the other. This part always comes with: Note that the cannot be turned off from a Control Head which is not the active one. Below is the list of the NMEA data sentences from which the Autopilot can obtain navigation data, and the order of priority in which the can use these sentences: Put your tools and other magnetic objects in storage places away from the Fluxgate Compass.


The vomnav MUST be at least 6 feet 1. These adjustments are very similar to the ones you made for Slow Speed Rudder Response.

To make a one degree course change to Port, briefly press the Red Key. You will not have to bleed your hydraulic system unless you have opened the hydraulic lines or run out of hydraulic fluid.

Comnav — Onnsports

To dodge around an object in the water, press and hold either the Green or Red Key. Hold the left hand inner end cap.

Turn the wheel of the highest helm pump in both directions until no more fluid comes out of the lines. Turn on the breaker for the Autopilot or connect the Power cable to the breaker. This might give you better steering performance than using the Slow Speed Rudder Response setting.

Vessel turns to Port Rate of turn: Check that a hard-over to hard-over time of 10 – 15 seconds comnxv be attained with your drive system. Cable 1 is 25 feet 7.